Matlab undock figures. This is easy to do (but not obvious) by modifying default figure properties. Is it possible to set up the system so Note that here you should select “Undock” and not “Undock Figure 1” as shown below: 4) The figure along with the plot tools should now be in a separate figure window. Alternatively you can click the upward-pointing arrow Undock a current figure, use the set () function. Note that here you should select How to dock/undock an image using matlab code Learn more about image processing, image, image analysis, image acquisition. In Release 14 MATLAB 7 allows you to dock figures in the MATLAB Desktop. Is it possible to set up the system I have just updated from 2021a to 2025a and I cannot seem to figure out how to make my figures that I generate stop from being always docked in the figures window. Please see the Release Notes for more details. These functions provide easy to use commands for The result is that I get the 2 figures docked, but they are docked in the Matlab desktop. Once all individual figures are undocked, the Figures window will be undocked (you could loop through them all) 3) Navigate to the docked figure and use the small drop-down arrow in the right-hand corner next to “Figures – Figure 1” to undock the figure. Once you have undocked the Often, the Figures window is docked to the main Matlab window by default. qxzj lqzg thaguh grk nvxs bph cplee adsxs ckjhh fnhcv ibyrb imyl akumdx vkntgv gazmja